Installation
BUILT-IN CABINET INSTRUCTIONS
These appliances are designed for both
CABINET OPENING DIMENSIONS (minimum)
Width
Depth
Height
12¼” | 24” |
23” + 2” handle | 23” + 2” handle |
32½” | 32½” |
|
|
ELECTRICAL CONNECTION
WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by a qualified electrician or contact Whynter Service Department
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent over- loading house wiring circuits that could cause a fire hazard from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards, it is strongly recommended that you do not use an extension cord with this appliance. However, if you must use an extension cord, it is absolutely necessary that it be a UL/CUL- Listed,
INSTALLING STAINLESS STEEL HANDLES
This appliance includes stainless steel handles that are not required to operate this appliance. To install the handles please follow the below instructions:
1.The gaskets are easily displaced by hand, no tools are necessary.
2.Use a
3.Install the handles tightly as shown with two screws, lock washers and flat washers provided. (DO NOT over tighten as this will cause damage to the handles and stainless steel door frames).
4.Replace the door gaskets to its original position.
8