Installation Instructions
1)As with all refrigeration equipment, this appliance should be settled for at least five hours prior to switching on the appliance.
2)The power supply must be an earthed 110V AC 60Hz mains supply.
1)Choose your required water supply method:
a. Water line supply - Use the provided water hose (17) to connect to your household water supply (Fig. 1). If assistance is required, please contact a certified plumber. Connect the water hose connector to a water faucet. Place the other end of the water hose into the water line connector (11) (Fig. 2) at the back of the unit. To disconnect the water hose connector from the water spigot, first make sure the water line is turned off, then simply pull back the release washer of the connector and pull apart (Fig. 3). To release the water line from the unit, simply unscrew the water hose on water line plug and pull the hose out (Fig. 4)
b. Manual water filling – You can use tap water or purified water. Remove the manual water fill compartment cover and place the filter net (19) in the compartment, pour water into the compartment until the compartment is full. Please ensure that you do not overfill or allow the water level to drop below the minimum level.
c. Commercial water bottle - Place a 3 or 5 gallon water bottle on the top of the unit using the water bottle adapter. We do not recommend using a water bottle with cap. To install the bottle supporter, insert it to the manual fill compartment (10 with the arrow pointing to the front of the unit. Turn the adapter clock wise slightly until the tabs on the inside of the compartment match up with the grooves on the protruding tube at the bottom of the adapter. Push down and then turn
IMPORTANT – DO NOT turn on the unit before installing the water bottle.
