2)Using the ON/OFF switch (1) at the side of the unit, switch the power ON. The POWER light (8) on the top of the unit will illuminate red.
3)Press the START button (2) at the top of the unit. The water level will be automatically checked and, if correctly filled, the red light will turn green. If the water level is still incorrect after 50 seconds, the LOW WATER light (9) will flash in orange and the POWER light (8) will flash in red. The unit will then switch to standby mode until the reservoir is filled in 18 minutes. Once you have correctly filled the reservoir, the unit will restart automatically. If the water level is still not filled for more than 18 minutes, the unit will stop. Press STRAT button to turn on the unit.
4)Press the STOP button (3) at any time, the unit will stop and the POWER light will turn to red. Please note that it will take approximately three minutes for the unit to reset itself.
5)Ice and cold water will be ready for dispensing in approx.
6)When the ice cube storage compartment is full, the POWER light (8) will turn orange and the unit will switch to
7)If the water level is lower than the minimum line, the POWER light
(8)will flash in red and the unit will switch into
8)To dispense ice cubes, crushed ice or iced water, just press the
relevant button - (4), (5) or (6). Place a cup, glass, etc, under the delivery outlet required.
Note: The ICE CUBE (4) and CRUSHED ICE (5) buttons cannot be used simultaneously.
Care, cleaning & maintenance
Cleaning the Unit
To maintain hygiene, it is important that the SELF CLEAN function is used on a regular basis.
Note: The START (2) and CLEAN (12) buttons cannot be pressed simultaneously.
1)Ensure the unit is switched on.
2)If the unit has not been used for a while, drain the unit using the following steps:
•Press the ICE CUBES, CRUSHED ICE and ICED WATER buttons individually, until corresponding tanks are empty.
•Remove the Drain Plug (14) at the bottom of the unit to empty the water tank.
3)Add a solution of one part vinegar to ten parts water into the manual water fill compartment (10) at the top of the unit. Ensure water level is above the minimum otherwise the unit will not self clean.
4)At the back of the unit, press the CLEAN button (12). The unit will automatically enter into Self Clean mode and the green CLEAN light
(7)will be illuminated.
5)Press the STOP button (3) after 15 minutes to end the Self Clean cycle.
6)Once the Self Clean cycle is complete, drain the water from the unit as described in step 2 above.
7)Flush the unit at least three times to remove the cleaning mixture. To do this, repeat step 1 to 6 above using water only. When in step 2, just press the ICED WATER button (6) only.
8)Refill the reservoir to resume the ice making function.
