Maintenance
1)Do not use any commercial chemical cleaning agent, acidic agent, naphtha decontamination powders, etc to clean the machine. Our recommended cleaning agent is vinegar and water solution.
2)Cleaning agent must be added through the manual fill compartment (10) only.
3)Do not allow water to be in the reservoir for more than a few days. The water reservoir should be drained and the SELF CLEAN function should be used.
4)To prevent injury, please do NOT touch the ICE or WATER outlets while the machine is switched ON.
5)If any part of this machine fails or is damaged, please contact our service department.
Troubleshooting
TROUBLE |
| REASON | WHAT TO DO | |
|
|
| 1. Plug into mains power | |
There is no POWER light | 1. | No power | supply. | |
2. | Fuse blown | 2. Replace fuse; unscrew | ||
on | ||||
|
| fuse holder (part 14) and | ||
|
|
| ||
|
|
| replace fuse | |
Power light on but the |
|
| Voltage must be 110v AC | |
compressor is not working | Incorrect voltage | |||
60HZ earthed mains supply | ||||
(buzzing noise only) |
|
| ||
|
|
| ||
Orange flashing light | Low water level or | Fill water manually/ Change | ||
water bottle or turn on water | ||||
(no/low water) is on | no water in reservoir. | |||
line | ||||
|
|
| ||
Water has poor taste or | Unit needs to be | See cleaning section | ||
odour | sanitized. | |||
| ||||
Particles floating in water | Water has high mineral | Use water with less | ||
content. | hardness. | |||
| ||||
|
|
| ||
Compressor is working but | 1. Low water level | 1. Fill water | ||
not dispensing ice or | 2. Mineral deposits | |||
2. Clean the unit | ||||
water | clogging tanks. | |||
| ||||
|
|
| 1. Turn on the unit using | |
|
|
| the On/Off switch and | |
| 1. Unit is not switched on. | press the Start button. Hold | ||
|
|
| a glass of water about 5 | |
|
|
| inches above fill | |
|
|
| compartment and pour | |
|
|
| water into unit. | |
Unit does not take in water |
|
| 2. Make sure that the red | |
2. The water level | ball is floating | |||
| ||||
| indicator (red ball) is not | 3. The unit stops taking in | ||
| moving. | |||
|
|
| water when the water tank | |
| 3. Water tank is about | is about half full. | ||
| half full | 4. Replace fuse; unscrew | ||
|
|
| ||
| 3. Fuse blown | fuse holder (part 14) and | ||
|
|
| replace fuse | |
Unit does not take in water | 1. Bottle supporter is not | 1. Maker sure the bottle | ||
installed properly | supporter is properly | |||
from a water bottle | ||||
|
| installed with the arrow | ||
|
|
|