IV. OPERATION INSTRUCTIONS
AIR FILTERS INSTALLATION
Your Whynter portable dehumidifier is equipped with a removable and washable filter. The filter removes large particles such as dust, pet hair and dander.
WARNING: NEVER OPERATE THE DEHUMIDIFIER WITHOUT THE FILTER
START OPERATION
1.Ensure that the appliance is connected to the power socket
2.Make sure the water bucket is placed in proper position.
3.Make sure filter is installed
4.When the unit is turned on for the first time, if the bucket full lamp lights up, just pull out the water bucket then push it back to the proper position.
5.Set the relative humidity level RH% by press- ing the up and down buttons. We recommend setting the RH% to at least 10% lower than the current RH%.
WHEN BUCKET FULL LAMP IS ON
The appliance will run continuously until the set RH% is reached or when the water bucket is full. When the water bucket is full, the Bucket Full indication lamp will light up and the dehumidifier will stop operating. Remove the water in the bucket with two hands, then place the water bucket back to it's proper position the machine will start operating again. This light will also illuminate when the bucket is removed or not properly inserted.
DEFROST
In the event frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run until the frost is evaporated. This happens when the appliance is operating in low temperatures (less than 53°F or 12°C), which affects the efficiency of the dehumidifier. When this happens, the defrost lamp will turn on and the machine will go into periodic defrost mode automati- cally. Defrost time may vary. If the dehumidifier freezes up, turn the appliance off for few hours and then restart. The appliance will not operate satisfactorily if the room temperature is below 41°F
7