CONTROL PANEL
NOTE: The control panel of the appliance you purchased may be slightly different according to the models.
|
|
|
|
|
|
|
|
|
| 2. Fan Button |
| 3. Continue Operation Button | |||||
| Controls the fan speed. The Turbo indicator light will | Programs the unit to run continuously until the water | ||||||
| come on when High speed is selected. The Normal | bucket is full. The humidity level cannot be set | ||||||
| indicator light will come on when Low speed is | |||||||
| (Buttons 5 and 6). The Continue indicator light will | |||||||
| selected. |
|
| |||||
|
|
| come on when this mode is selected. | |||||
| Set the fan control to Turbo for maximum moisture | |||||||
|
|
|
|
| ||||
| removal. When the desired humidity level is achieved |
|
|
|
| |||
| and quiet operation is preferred, you can set the fan |
|
|
|
| |||
| speed to Normal. |
|
|
|
|
| ||
| 4. Filter Reset Button | 5 /6. | / | Humidity Control / Timer Button | ||||
| The check filter feature is a reminder to clean the air | |||||||
| The humidity level can be set within a range of | |||||||
| filter for efficient operation. Filter indicator light will | |||||||
| 35%RH (Relative Humidity) to 85%RH in 5% | |||||||
| come on after approximately 250 hours of operation. | |||||||
| increments. |
|
| |||||
| After the filter is cleaned and replaced, reset the unit |
|
| |||||
|
|
|
|
| ||||
| by pressing the Filter Button and the Reset indicator |
|
|
|
| |||
| light will go off. |
|
|
|
|
| ||
|
|
|
|
|
| |||
| 7. Timer Button |
| 8. On/ Off Button | |||||
| The Timer button enables you to initiate the Auto- | Turns the dehumidifier on and off. | ||||||
| start and |
|
|
|
| |||
| Use the | and | buttons to increase or decrease |
|
|
|
| |
| the desired time interval in 0.5 hour increments. To |
|
|
|
| |||
| cancel the selected timer setting, press the Timer |
|
|
|
| |||
| button again or turn the unit off. |
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|