Steps to Programming
Your Curtis Cafe System is Factory
WARNING HOT LIQUID, Scalding may occur. Avoid splashing.
Place an empty container under the dispensing nozzles while programming.
All programming is performed at the control panel (illustration, right).
The Hot Water button is used for only for dispensing hot water and does not require any
programming. Water is dispensed as long as the Hot Water button is held down.
The STOP/WASH BUTTON has several functions. This button is used to stop a Portion Control dispense cycle. It is used to wash out the mixing and dispensing systems and it is used to enter programming functions.
Product % Ratio
This controls the amount of dry product that is metered from the hoppers. This can be programmed from 10% to 100% of the capacity of the dispensing system. By counting LED flashes you can determine the product % ratio currently set for this dispense button (see table).
Enter
Program Mode
Enter
Product % Ratio
Enter Program Mode – press and hold STOP/WASH for about ten [10] seconds until all lights start blinking.
To program Product % Ratio, press and hold the selected PUSH button for approximately one second, then release. The current setting will be indicated by LED flashes.
Number of | Volume | ||
Flashes | |||
1 | 10% | ||
2 | 20% | ||
3 | 30% | ||
4 | 40% | ||
|
|
|
|
10 | 100% | ||
|
|
|
|
Change
Product Throw
Exit
Program Mode
To change the product throw, press and hold the button until light starts quick flashing. Each quick flash increases the amount by 10%. Release the button when the desired throw amount is achieved. After releasing the button, the number of blinks represent the new setting.
To exit the Powder Dispensing Mode, push the other PUSH button.
Portion Control Liquid Dispensing Mode
This program adjustment allows you to setup the machine to automatically dispense a preset volume of coffee. When the user makes a PUSH button selection, the SD2 unit dispenses only the volume of coffee programmed by the Portion Control Dispensing Mode. By setting the unit for Portion Control Dispensing, you have locked out the manual dispense feature.
Enter
Program Mode
Enter Program Mode – press and hold STOP/WASH for about ten [10] seconds until all lights start blinking.
Select & Change
Preset Liquid
Dispense
Stop & Exit
To select & change the Portion Control Dispensing Volume – while in the programming mode, press and hold the selected PUSH button until the liquid begins to flow, then release. The timing starts when liquid begins to flow.
Stop flow and Exit – When the desired volume is achieved, press this PUSH button once again to stop the dispensing.
You have now set the timing for this button and have exited the programming mode. Pressing the selected dispense button now will provide the liquid volume that you just set. To reset the timing, you must start again by entering the programming mode.
2
