Williams Sound TEL 40 user manual For Wall Plate Installations

TeleTalker ® Model TEL 040

Installation Guide & User Manual

For Wall Plate Installations

If you prefer, the TeleTalker can also be mounted on a studded wall phone plate. If you don’t have a phone plate installed, talk to your phone company or local phone products store.

Step 1: Clip the plastic wall mounting bracket (included) into bottom of the TeleTalker base unit. (see fig. 7) Make sure the tabs snap in securely. This will make the base unit level with the wall.

Step 2: Reverse the handset hanger found in the handset cra- dle to prevent the handset from falling.

Step 3: Plug the short line cord into the jack on the top of the telephone and thread the line through the chan- nel to the cavity on the back of the base unit.

Step 4: Hold the telephone next to the wall-phone jack and plug the line cord into the jack, leaving any slack in the base unit cavity. Then push the phone against the mounting studs so the studs are hooked into the upper and lower keyhole slots of the phone. Slide the phone down until it snaps into place. (see fig. 7)

Step 5: Check for a dial tone. If you can’t hear a dial tone, see In Case Of Difficulty, page 12.

Note: To remove a wall-mounted telephone, slide the phone up and pull it slightly away from the wall. Disconnect the line cord by squeezing the clip on the modular plug and pulling it from the jack.

fig. 7:Wall Installation Short Wall Cord

Wall Mount

Bracket

Studded Wall

Phone Plate

8 Williams Sound ®

Helping People Hear