![](/images/new-backgrounds/1145181/14518125x1.webp)
Replacement of Motor
WARNING: DISCONNECT ELECTRICAL POWER TO THE MACHINE BEFORE PERFORMING ANY MAINTENANCE.
1.Disconnect electrical power.
2.Remove four screws from base. With assistance of the second person, lift base from stand.
NOTE: Place base on bench. As an alternative, the stand may be used to support the base while remov- ing drive motor screws.
3.Place base on bench with underside of the base facing up.
4.Remove four hex head screws, nuts, and wash- ers from the motor base.
5.Remove motor
6.Remove motor from base.
7.Loosen set screw in pulley (18). Remove pulley.
8.Align set screw in pulley with flat on motor shaft and install pulley. Do not tighten set screw.
9.Install replacement
10.Install and tighten four hex bolts, nuts, and washers in the motor base.
11.Position pulley (18) on motor shaft so the
12.Place assembled base on stand. Secure with four screws, washers, nuts.
13.Connect electrical power and operate machine to check operation.
13