Wilton JWBS-16B manual Assembly and Setup, Base Support Extension

Assembly and Setup

Base Support Extension

1.Attach straps (A, Fig. 1A) to extension base (B, Fig. 1A) with (2) 5/16-18 button head cap screws (C, Fig. 1A) and with (2) 5/16 flat washers (D, Fig. 1A). If needed punch holes through striping decal. NOTE: Leave screws slightly loose.

2.Repeat for opposite end of extension base.

3.Insert straps through slits in base of machine lining up holes in machine base with tapped holes in strap (Fig 1B)

4.Attach straps to machine base using (2) 5/16- 18 button head Cap screw (E, Fig. 1C) and (2) 5/16 flat washers (F, Fig. 1C).

5.Repeat for opposite end of extension base.

6.Tighten all (8) button head cap screws with the 5 MM hex wrench provided.

7.Attach the handle (C, Fig. 2) to the hand wheel (D, Fig. 2).

9

Figure 1A

Figure 1B

Figure 1C