CARPET INSPECTION:
Determine precisely what areas you are going to clean. Note problem areas in the carpet or tack strip. Look for loose carpet, heavily damaged areas, discolored stains, or grease spots that will require prespotting. Note the carpet type. Check the availability of hot water, drains, and suitable electrical outlets. If the carpet is loose or worn, have it repaired before attempting to clean it.
Plan the cleaning route, work from the most remote area towards the exit. Try not to travel over the cleaned areas when getting fresh water or dumping old. Furniture should be moved out away from the walls before cleaning. If furniture is moved back in place before carpet is completely dry, place plastic or foil protectors under the legs to prevent possible carpet staining. When possible use a Windblower (AM3) and open all windows and doors to speed carpet drying.
ACCESSORIES:
The D100 can be used with the following Windsor equipment: Deluxe Hand Tool (86000020 – PRV NO. HT), Pile Jogger (86041760 – PRVNO. PJ2A), Standard Floor Wands(SFW, 86000610 – PRV NO. 89227, 86000600 PRV NO. 89226, & Wind Blower carpet dryer(AM3). Contact an authorized Windsor dealer for assistance in choosing the right equipment .
GENERAL INFORMATION:
On heavily soiled carpets, or on areas of high foot traffic, it may be necessary to use a prespray or traffic lane cleaner applied with a
As the carpet is being cleaned, check to see if there is foam building up in the recovery bucket. Add a little defoaming compound to the recovery tank but never to the solution tank.
OPERATIONS
For infrequent use or long periods of storage, flush the system with a neutralizing solution of 1 quart white vinegar mixed with 2 gallons hot water. Flush the system with clean hot water after neutralizing.
For hose fitting lubrication, use a light silicone lubricant which will not damage
PROTECT THIS MACHINE FROM FREEZING.
EQUIPMENT SET-UP:
1.) Plug power cable from machine into properly grounded wall outlet.
2.) Turn vacuum motor switch on and off to make sure there is electrical power at machine.
3.) Connect vac hose to machine. Slide the swivel cuff over the outlet on the tank.
4.) Connect the hose set to your machine and wand. Pull back the knurled collar on the quick disconnect coupler and push onto the connection on the chassis. To avoid leaks, check to be sure a positive connection was made.
5.) Using a clean container, fill the solution tank with clean, hot water. Mix in a non- foaming cleaning concentrate for use in hot water extraction machines following the manufacturer's instructions, as printed on the container. When using a powder cleaner, premix with hot water in a clean container before adding to the solution tank.
6.) Turn pump and vacuum switch to the on position.
7.) Start cleaning.
D100 86038620 05/21/07 |
