Windsor LB2000 manual Technical Specifications, Dimension/Capacity

TECHNICAL SPECIFICATIONS

ITEM	DIMENSION/CAPACITY
Construction	Heavy-duty die cast aluminum deck
	with heavy-duty rubber bumper,
	tubular steel self adjusting handle
	with die cast aluminum handle
	housing.
Motor	1.75 hp
Transmission	Direct drive from motor shaft.
Pad speed	2000 r.p.m.
Electrical system	115 volts, 60 Hz
Cable	75’ [22,9 m], 14/3, built in cord wrap.
Switches	Dual levers with safety lock.
Pad Holder	∅20” [50,8 cm] flexible disc
Wheels	Four ∅5” [∅12,7 cm], 1.25” [3,2 cm]
	wide, non-marking tread.
Handle	∅1.5” [∅3,8 cm] tubular steel, self
	adjusting handle consistently
	maintains full contact with the floor,
	and easy to use thumb activated
	safety lock.
Dimensions (L x W x H)	32” [81,3 cm] X 23.9” [60,2 cm] X
	48.4” [122,9 cm]

NOTE: Always use a pad which has been designed for electric ultra high speed burnishing of at least 2000 rpm.

The sound pressure level at the operator’s ear was measured to be 70 dBA. This was a nearfield, broad-band measurement taken in a typical industrial environment on a tile floor. This appliance contains no possible source of impact noise. The instantaneous sound pressure level is below 63 Pa.

3-1 LB2000 980088 03/08/03