MACHINE OPERATION
For indoor use only.
When using the pad, always keep the machine moving when in contact with the floor.
High starting torque. Hold machine firmly with both hands.
1.Ensure that the pad driver is in good shape. Install or change pad if necessary.
2.Plug the machine into a wall outlet as described in the grounding instructions.
3.Lower the handle by unlocking the adjustment handle and moving the handle into position. Relock the handle when it is in a comfortable position.
Insure that handle is locked in position before starting machine.
4.Push the safety lock forward, unlocking the switch levers.
5.With the safety lock forward, squeeze one or both of the switch levers, turning the machine on. (These levers can be operated independently of each other). The safety lock will not
6.To stop the machine, release the switch levers.
7.Do not let machine rest on pad. When finished with the machine, return handle to the storage position.
NOTE: The machine is equipped with a circuit breaker to protect the motor in the event an overload condition occurs. The circuit breaker is located on the handle. Push the reset button to restart the machine. If the breaker trips again, correct the cause of overloading before proceeding.
OPERATION
DAILY MAINTENANCE
1.Inspect power cord for wear. To prevent electrical shock replace cords with frayed or cracked insulation immediately.
2.Place machine in the storage position.
3.Check pad condition. Change if soiled or torn.
PAD INSTALLATION
1. Lay machine back, exposing the under side.
Ensure pad is centered on pad driver. Pull pad to edge of pad driver in several directions to check for proper engagement.
NOTE: Use care when replacing center lock to prevent cross threading.
86309580 FLOOR POLISHER 10/08/08 |
