15.) Ventilate the room when cleaning has been completed. Keep all traffic off the floor until it is thoroughly dry.
16.) When done cleaning for the day bring the machine to a utility sink and floor drain. Perform the daily/regular maintenance. Set the recovery tank aside so solution tank will dry.
CAUTION:
When not using the machine put the brush in the storage position.
(see daily maintenance on page 8) Leaving the brush on the floor for long periods of time may ruin it.
To Use an Accessory Tool:
1.) Turn the machine completely off and unplug it from electrical outlet.
2.) Connect the solution hose to the brass fitting on lower left side of machine.
3.) Connect the vac hose to the left side of the dome (side with white hose cuff).
4.) Fill the solution tank.
5.) Plug the machine in and turn on only the vac/pump switch. Also place the water control switch in the “HIGH” position.
CAUTION:
Using accessory tool with brush switch on may damage floor.
6.) Turn off the machine and unplug it from electrical outlet before disconnecting accessory tool.
Approved Accessory Tools:
Standard Floor Wands
(SFW, SW, or
Deluxe Hand Tool (DHT)
Upholstery Hand Tool (UPH3)
Floor Surface Inspection:
Determine precisely what areas you are going to clean. Note the problem areas in the carpet or hard floor. Look for loose carpet, heavily dam- aged areas, discolored stains or grease spots that will require prespotting. Note the carpet or hard floor type. Check the availability of hot wa- ter, drains, and suitable electrical outlets. If the carpet is loose or worn or there is hard floor sur- face flaking, have it repaired before attempting to clean it.
Plan Cleaning Route:
Work from the most remote area towards the exit. Try not to travel over the cleaned areas when getting fresh water or dumping old. Furni- ture should be moved away from the walls be- fore cleaning. If furniture is moved back in place before floor is completely dry, place plastic or foil protectors under the legs to prevent possible staining. When possible use a Windblower (WB3) and open all windows and doors to speed drying.
General Cleaning Information:
Vacuum carpet or sweep hard floor first! Al- ways take the time to thoroughly vacuum carpet or sweep floor before using the extractor.
On heavily soiled floors, or on areas of high foot traffic, it may be necessary to use a pres- pray or traffic lane cleaner applied with a sepa- rate sprayer. Do not add presprays to the ma- chine’s solution tank. If a spotter is used, follow the manufacturer’s instructions exactly as printed on the label. Spotter left on the floor may bleach or brown it permanently.
Shag or deep pile carpets may require several passes from different directions, but the opera- tor must be careful not to over saturate the car- pet. Make several passes without spray to ex- tract as much moisture as possible.
Rinse carpet after cleaning so that sticky soap
98353 | 7 |
