Windsor SPD This product contains moving parts, Suggested Service Parts List, Dailv Maintenance

WARNING OF POTENTIAL INJURY

This product contains moving parts.

To reduce the risk of injury; unplug the machine before servicing.

Maintenance and repairs must be done by qualified personnel ONLY.

CAUTION:

Using non-Windsor parts to repair this machine will void the 6-3-1 warranty. Warranty information is located on the back of this manual.

Suggested Service Parts List

		DESCRIPTION		PART NUMBER
	Belt			11031
	Brush Bearing			09019
	115V Cord Assembly (USA/Japan) 23572
	230V Cord Assembly (Europe)			23178
	Dome	Assembly		28034
	Dome	Gasket		35060
	Hose Cuff. Short Blue			27508
	Hose Cuff. Longer Blue			27354
	Hose Cuff, White			27079
Jet Assembly				44055
Jet				44061
Jet Seal				44051
Jet Body w/Seal				44052
Manifold Assembly (No Jets)				54094
Pump Service Kit				47176
Screen/Filter,			Dome	34140
Screen/Filter,			Solution Tank	73250
Solution Release Cable				27665
Solution Release Lever				51200
	115V Switch			72074
230V Switch				72121
Valve				84134

Dailv Maintenance:

These procedures are followed at the end of each work period to extend the life of the ma- chine.

1.) Empty unused cleaning solution by disconnecting clear hose on back of machine and pouring into floor drain.

2.) Inspect and clean solution filter screen inside tank and vac intake screen inside dome.

3.) Flush the system. Fill solution tank with 1 or 2 gallons (4 - 8 liters) of clean hot water. With machine over floor drain turn on vac/pump switch until solution tank is empty.

4.) Inspect spray pattern of jets. Remove jets and rinse if clogged.

5.) After each use, rinse recovery tank with fresh water. Periodically inspect the recovery tank and decontaminate if necessary, using a Hospital Grade Virucide or a l-l 0 bleach to water solution. Waste water should be disposed of properly.

6.) Remove any lint or debris from brush.

7.) Inspect power cord. Remember, this cord will lay on a damp surface.

Warning:

IMMEDIATELY REPLACE WORN OR

FRAYED POWER CORDS.

8.) Inspect hoses. Worn or cracked hoses may cause loss of vac pressure.

9.) Place the brush in the storage position. Press back slightly on the main handle, and place the brush adjustment lever in the “STORE”position.

For infrequent use or long periods of stor- age, flush the system with a neutralizing solution of 1 quart (1 liter) white vinegar mixed with 2 gal- lons (8 liters) hot water. Flush the system with clean hot water after neutralizing.

8

98353