Winegard 1000 Removing the Reflector and LNB Assembly, Reflector nut not shown, Turret, Bolt

Models: 1000

1 8

Page 3

1If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna, remove the power inserter and SWM splitter; these will not be used.

2Remove the four reflector nuts and bolts, and remove the dish. Set the nuts and bolts aside.

3Disconnect the coaxial cables from the turret. Note that the D port will not be present on a SWM TRAV’LER antenna.

4Remove the bolt holding the cable harness to the unit, and detach the cable harness from the lift arm.

Bolt	Lift
	Arm

5Set the bolt aside; you will need this later.

Image 3

Contents

2452138 Replacement DISH LNB AssemblyFor Technical Services email help@winegard.com or callRaising the Antenna Pay attention to the pinch points as the antenna raises. See belowUnplug the TRAV’LER interface, and remove Bolt Removing the Reflector and LNB AssemblyReflector nut not shown TurretBolts Installing the DISH Reflector and LNB AssemblyReflector bracket Skew housing Stiffener plateThe bracket should be installed so that the LNB arm assembly is at the bottom of this plateF-cap Setting the IDU for DISH Re-packaging the Removed LNB for OE-DISH Users Re-packaging the Removed LNB for RP-SK21 UsersWinegard Company 3000 Kirkwood Street Burlington, IA