Winegard GS-1100, GS-2200 warranty Tips

WARNING:

INSTALLATION OFANTENNAS NEAR POWER LINES IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.

INSTALLATION

This SENSAR antenna may be installed inside or outside on any mast or pole. DO NOT MOUNT OVER CHIMNEY OPENING.

STEP 1. Make sure "W" opening is on bottom side of antenna head, foot embossing points down. Slide metal mounting bracket up into back bracket on antenna and attach with pins and E-clips. See Figure 1.

STEP 2. Insert "U" bolt thru mast clamp and mast bracket and start hex nuts onto "U" bolt. See Figure 1.

STEP 3. Slide mast thru "U" bolt and tighten hex nuts with 7/16" wrench.

Model GS-1100 (Non-amplified Models ONLY)

Attaching Downlead Cable

STEP 4. Attach downlead coax cable to F-jack on back of antenna head and tighten securely. (Figure 3). Tape downlead to mast and run coax cable to TV. Point the front of the antenna (with Winegard logo) at broadcast towers of stations you want to receive.

STEP 5. Attach "F" connector to downlead and connect to "F" jack on TV.

Figure 2	DOWNLEAD COAX CABLE FROM
	PREAMP OR AMPLIFIED ANTENNA	POWER
	ANT.
		INJECTOR

AC ADAPTOR
(SUPPLIED)	TV
	POWER IN
	LED
	6’ STANDARD
	COAX CABLE
	(SUPPLIED)

COAX CABLE TO DIGITAL TV, DIGITAL CONVERTER BOX, DISTRIBUTION AMP OR SPLITTER

Models GS-2200 (Amplified Models ONLY)

Attaching Downlead Coax Cable

If using the power supply, follow these steps.

STEP 4. Attach “F” connector on downlead coax cable to the power injector jack marked “ANTENNA”. Point the front of the antenna (with Winegard logo) at broadcast towers of stations you want to receive

STEP 5. Attach “F” connector on coax cable from DTV, Digital Converter box, Distribution Amplifier, or splitter system to jack on Power Injecter marked TV.

STEP 6. Connect one “F” connector on supplied black RG-6 coax cable to the power injector jack marked “PWR IN”. Connect the other “F” connector on supplied RG-6 coax cable to jack on supplied AC wall transformer. See Figure 2. You can use a longer piece of RG6/U coax cable if required up to 100 feet between the AC adaptor and power insertor if required.

STEP 7. Mount the power injector to the wall using supplied screws. Plug in AC wall transformer to household wall outlet.

Figure 1

(2) Pin

U-Bolt

(2) E-Clip

Mast Bracket

(2) Hex Nut

Mast Clamp against Bracket

Pipe

Figure 3

Attach coax here.

TIPS:

If splitting the signal to multiple TVs or combining with another signal source, it is strongly recommended that the power injector be installed between the antenna and the splitter/combiner input. In this case, the cable connection from the “TV” jack of the power injector goes to the splitter input or valid combiner input. Use splitters rated from 54-806 MHz or wider bandwidth (commonly 5-1000 MHz) for over-the-air television signal distribution.

Additional distribution/inline amplifiers must be installed FOLLOWING the TV output of the power injector, NOT on the downlead cable line connecting to the ANTENNA port. Check TV picture quality, if the power injector LED is glowing when powered, and antenna alignment prior to adding additional line amplifiers.

A maximum antenna-to-power injector length of 150 feet RG-6 or 150 feet RG-59 is acceptable.