Winegard MV-3500 manual Installation Wiring, Cable entry installation, Installing The Power Switch

Installation • Wiring

Cable entry installation —

1.Decide the best location for the cables to en- ter the vehicle, keeping in mind the desired location for the switch and receiver.

Drill a 3/4” hole in the roof, push wires inside. Make proper connections (remember you must have filtered +12 VDC power source).

2.Place cable-entry plate over hole and cables. Screw in place. Seal plate and screw holes with approved sealant (not included).

FIGURE 7
CABLE-	CABLE CLAMP -
ENTRY	EVERY12”-16”
PLATE

3.Depending on the length of the cable on the roof, you may need to use cable clamps or wire ties (not provided) between the unit and your cable-entry plate. Clamping the cable every 12”- 16” should eliminate any unnecessary cable movement, Figure 7, see above.

INSTALLING THE POWER SWITCH

1.Decide the location of the power on/off switch.

Be sure the switch is turned off before you be- gin!

See diagram below.

Wall or panel mount: Drill 1-1/4” hole, pull wires through wall or panel.

Surface mount: Determine location and direction of box. Mount box feed wire into one of the box openings.

Select plate cover (brown or white provided) and snap the rocker switch into the switch plate. Be sure switch is off!

2.Connect filtered +12 VDC power from ve- hicle, using red spade connector, to isolated spade on switch.

3.Connect red power wire from MV-3500 using red spade connector to center spade on switch.

4.Connect vehicle ground and black ground wire, using yellow spade connector, to silver spade on switch.

FIGURE 8

INSTALLING THE POWER SWITCH DIAGRAM

ON/OFF ROCKER

WITH LIGHT

(SHOWN IN OFF

POSITION.)

STEP 4		STEP 2
TWO BLACK GROUND WIRES
1 FROM VEHICLE	STEP 3	FILTERED
1 FROM SATELLITE DISH	RED POWER	+12 VDC

WIRE SATEL-	FROM
	VEHICLE
LITE DISH

9