Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update is complete. Don’t remove the AC mains lead during the update. Removing the AC mains lead while the update is in progress may damage the unit.

The unit’s display during the update

e.g.,

Software of this unit can be updated automatically by following method in standby mode at the specified time.

(Default setting is 3 a.m. > 78, Software Update in Standby)

-From broadcasts

-From Internet§

§Network connection and setting are required. (> 15, 18)

If a software (firmware) update is available, a notification is displayed.

New software version has been found. The software will be updated automatically after this unit is switched to standby.

Do not disconnect the AC mains lead.

It is displayed on the channel information (> 21) when the software (Firmware) can be updated immediately.

e.g.,

1

 

10:30 All Digital Channels

Dogs and Cats

Now

Select favourites

9:00 - 11:00

Software upgrade

Rating: PG

Dolby D

 

To execute, push the red button while the channel information is displayed, and follow the instructions on the screen.

Update of the software (firmware) will start when the unit is turned to standby mode.

When “FINISH” is displayed, update of the software (firmware) has completed.

It may take up to a few hours until the update is completed

depending on the network or broadcast environment.

The timer recording always takes preference over the software (Firmware) download; if the timer recording is scheduled to start, the downloading will be performed at the next opportunity.

You can also download the latest software (firmware) from the following website. http://panasonic.jp/support/global/cs/

80 VQT4C71

Page 80
Image 80
Panasonic DMR-XW390 operating instructions Software Firmware Update