Parts Included • Tools Needed • How to Unpack
The Winegard MV3500T is designed specifically for use with motorized recreational vehicles. Winegard recommends using a qualified installer familiar with RV structure and wiring to ensure proper installation and to prevent damage to RV or dish.
PARTS INCLUDED:
1 Radome
1 Power switch
1 Wall plate (white)
1 Surface mount box
1 Cable entry plate
3 Base feet
large yellow flag connector 2 small red flag connectors
All required screws, washers, bolts, and nylocks 1 base with electronics, dish, dual LNBF Silicone sealant
Surface Wipes
30’ Coax Cable
30’ Power Cable
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level | 3/8” Open end wrench |
Drill w/3/4” bit | 7/16” Open end wrench |
Sealant (consult RV manufacturer for proper type | |
Phillips screw driver #2 | for your roof material) |
UNPACKING THE UNIT
1. Open box and remove packing material.
If using knife to open
!carton, BE CAREFUL. Do not cut the dome on the unit.
BE CAREFUL when
!removing unit. Dome is attached to base by only 3 pieces of tape,
NOT BY SCREWS.
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
2.Lift dome out of box vertically. Then lift unit out of box vertically. Do not turn box and “roll” out, or turn upside down to remove.
USE 2 PEOPLE
when removing the unit from the carton.
DO NOT PAINT DOME!
!Painting dome will cause signal degradation.
REV. 12/05
2