Installation • Wiring
Connecting the receiver —
Connecting one receiver
1.Connect the coax cable from the MV3500T to the “SATELLITE IN” on the receiver.
2.See page 5 of Operations Manual for receiver
Connecting two receivers
1. Connect the coax cable coming from the |
MV3500T to the “ SATELLITE IN” input on the |
primary receiver. The primary receiver is the |
receiver used most often and will toggle between |
satellites. |
2. Run a second cable through the empty Heyco |
opening and connect to the ground |
feed through and connect the other end of this |
cable to “Satellite IN” input on the second re- |
ceiver. NOTE: Secondary receiver will not |
toggle. |
3. See page 5 of Operations Manual for receiver |
Initializing & replacing the dome after connecting the receiver(s) —
1.Be sure vehicle is in a location free of all obstruc- tions and with a clear view of the southern sky.
2.DO NOT MOVE VEHICLE during the first initial- ization. Power up unit, turn on receiver. FOR THE FIRST TIME ONLY, the unit may take up to 10 min- utes to initially find the satellite signal. The GPS is also initalizing at this time. After the GPS initializes, the unit will begin searching for the correct satellite.
3.If the GPS does not initialize at this time, turn off the unit. You may need to move the GPS an- tenna to a different location on your roof. After you move the GPS, DO NOT SECURE TO ROOF.
4.TEST YOUR SYSTEM BEFORE SECURING THE GPS ANTENNA. Make sure the TV/receiver has found the correct satellite.
5.After the correct satellite has been found, secure
GPS antenna by removing adhesive backing and securing to roof.
GROUND BLOCK
CUSTOMER/INSTALLER
PROVIDES COAX FOR
SECOND RECEIVER
PRIMARY
RECEIVER
USED ONLY WITH
A SECONDARY
RECEIVER
CONNECTOR
UNIT BASE
APPLY SILICONE BEAD
AT BASE OF CONNECTOR
APPLY SILICONE BEAD IN HOLE WHERE COAX ENTERS
7