Quick Reference Guide
NOTICE!
This model is PRESET for DIRECTV® receivers.
If you have a DISH Network® or ExpressVu® (Canada) receiver, you must change the numbered switches inside the dome.
TO CHANGE SWITCHES INSIDE DOME —
1.Remove screws holding dome to base and remove dome. Place dome in safe spot to avoid damage. Switches will be set at 101° for DIRECTV®. You may be changing these switches.
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
0 = UP | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 1 | 1 = DOWN |
(#1 represents Switch DOWN; #0 represents Switch up)
Sat. Rcvr. Mt. Option |
| Switch Set Position |
|
|
|
| ||
................................... | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
DIRECTV | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 1 |
(FACTORY PRESET) |
|
|
|
|
|
|
|
|
DISH NETWORK | 0 | 0 | 0 | 1 | 0 | 0 | 1 | 1 |
ExpressVu | 0 | 1 | 0 | 1 | 1 | 0 | 1 | 1 |
SWITCH SETTINGS SHOWN BELOW
0= UP 1= DOWN
2. Determine which programming you will be using. This will determine how you set your switches.
For DISH Network set switches to 119°. | For ExpressVu®, set switches to 091°. |
0= UP
1 2 3 4 5 6 7 8
0 | 0 | 0 | 1 | 0 | 0 | 1 | 1 |
1= DOWN
0= UP
1 2 3 4 5 6 7 8
0 | 1 | 0 | 1 | 1 | 0 | 1 | 1 |
1= DOWN
MOUNTING
FRONT OF VEHICLE
CENTER LINE OF VEHICLE
MV3500- T
REAR BASE FOOT (MUST BE PARALLEL TO CENTER LINE)
BACK OF VEHICLE
!mounted towards BACK of vehicle and PARALLEL to center line. Failure to do
so may cause unexpected operation!Rear foot MUST be
DirecTV® receivers must be set to the two satellite, oval dish setting. Refer to your receiver manual.
DISH Network receivers must either have the check switch set for SW42 or unknown, no satellite found. See page 5 in Operation Manual.
The satellite system has two modes of operation; Tracking Mode and Sleep Mode. When you first turn the unit on, it enters Tracking Mode. In this mode the unit will search and actively follow the satellite as the vehicle trav- els. Tracking mode ends when the unit has successfully finished its search and the vehicle has not moved for six minutes.
Sleep Mode, this is the unit at rest mode. During Sleep mode the dish will toggle between primary and second- ary satellites as you change channels with the remote. The unit enters Sleep mode about six minutes after a successful search if stationary, or six minutes after the vehicle stops moving.
4
