Winegard rm-4610 owner manual ³ Figure, If YOU are Using AN Exten, Cutting Shaft, LENGTH, a

STEP 19. The directional handle and threaded rod will fit roofs up to 5-1/4" thick. If you are using wedges to compensate for roof/ ceiling slope, be sure to allow for this extra thickness. You may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directional handle by 2-1/4".

WITH ROOF WEDGE

Measure from top

of roof wedge to ceiling.

TOP OF

ROOF WEDGE

WITHOUT ROOF WEDGE

Measure from top of roof to ceiling.

TOP OF

ROOF

³ FIGURE 13

CEILING ³

FIGURE 14

³

CEILING

³

Plastic

Plug

STEP 20. Press the directional handle onto the hub. Point the arrow on the directional handle towards the rotate/lock lever to orient to the splines.

Spacer	STEP 21. Install the washer and nut on the
Spring
	threaded rod. Tighten the nut enough to snug
	the directional handle to the hub.
	STEP 22. IF YOU ARE USING AN EXTEN-
Hub	SION, adjust the total length of the directional
	handle and extension by cutting the directional
	handle. After adjusting parts for proper roof
	thickness, glue the extension to the directional
Worm	handle. Use ABS (plastic pipe) glue.
Gear	NOTE: For roofs thicker that 5-1/4", a longer
Threaded	aluminum hex shaft will be needed. Contact
Rod	Winegard Company for this part.
Ceiling	CUTTING SHAFT	FIGURE 14A
Plate	LENGTH, Figure 14A:
	Flip down handle on
	the elevating crank
	handle. Slide elevating	Elevating shaft
	crank handle up shaft	Cut elevating
	until snug against
Directional		shaft at inside
	directional handle.	surface of
Handle
	Mark the elevating	crank handle
	shaft at inside bottom	housing; shaft
		goes through
	surface of crank
		hex-shaped
	handle housing, Figure	opening by
	12. Cut shaft at mark,	screw.
	after removing crank	Crank Handle

handle. Reinstall crank.

STEP 23. Check system for proper operation. Elevate dish with crank handle. A minimum of 14 turns is needed to elevate dish. Then, move directional handle with dish elevated. Directional handle should turn freely. If possible, have someone watch to make sure coax does not bind or interfere with dish movement.

9