Quick Reference Guide
This model is PRESET for DIRECTV receivers.
If you have a DISH Network or BELL TV receiver, you must change the numbered switches (see figures below).
|
| FACTORY PRESET | TO CHANGE SWITCH SETTINGS FOR DISH | ||||||||||||||
|
| NETWORK. SIMPLY MOVE #4 & #7 TO DOWN | |||||||||||||||
DIRECTV SWITCH SETTINGS | POSITION (#8 SHOULD REMAIN DOWN ALSO). | ||||||||||||||||
|
|
| DIRECTV |
|
|
| DISH NETWORK | ||||||||||
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | |
|
|
|
|
|
|
|
|
|
| ||||||||
BELL TV
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
KEY
0 = up
1 = down
DISH NETWORK HYBRID
1 2 3 4 5 6 7 8
Installing unit on roof of vehicle —
! Install in DRY conditions only!
IMPORTANT! Do not install this system in the rain, or under any wet conditions. Moisture may affect electron- ics and void your warranty!
1.For best performance and to reduce signal acquisi- tion time, park vehicle on a level surface; level the RV.
2.Select a level spot on your roof for installation.
WARNING: Level the base front to back and side to side. If base is not level the antenna may require more time to locate the correct satellite or may not locate the correct satellite.
Hybrid Mode settings are for use in areas where the standard DISH Network settings fail to provide HD programming.
FIGURE 1
2 3 4 5
4.After selecting location for unit (see Step 2), place the unit on the centerline of the vehicle.
5.Position base so that cables exit toward the rear of vehicle.
FIGURE 2
3. Ensure proper distance to other rooftop equipment is | FRONT OF VEHICLE | ||
At least 12” | At least 12” | ||
maintained. | |||
Be sure no |
| RoadTrip Minimax | |
satellite “line of sight”; see chart below. |
| MUST Face FRONT | |
Using this chart, determine the minimum distances to |
| ||
| of Vehicle | ||
other equipment. |
| ||
|
| ||
Obstruction Ht. | Unit Clearance | Cable connections | ||
8” | 15” | |||
10” | 20” | MUST face REAR | ||
12” | 25” |
|
| |
The distance from the edge of the roof to the rear cor- | ||||
15” | 35” | |||
ner of any foot should be at least 12” on both sides of | ||||
|
| 3the dish to ensure proper installation. | ||
