Winegard SS-2000, SS-1000 installation instructions Risk Electric Shock Do not Open

IMPORTANT SAFEGUARDS

WARNING: TO REDUCE RISK OF FIRE OR

ELECTRICAL SHOCK,

DO NOT EXPOSE TO RAIN OR MOISTURE.

(Not applicable to mount and antenna)

Adjusting your Square Shooter for best reception when trying to receive signal in an area with reflected signal.

For the best reception, we suggest you have someone watching the TV while you adjust the antenna.

NOTE: See Figure 5 for bolt locations covered in the following steps.

CAUTION!

RISK OF

ELECTRIC SHOCK.

DO NOT OPEN!

Dangerous voltage inside enclosure

Refer to operating, mainte- nance and safeguard literature accompanying unit.

STEP 1. To adjust azimuth, loosen the 2 bolts on		T			T
the pipe clamp and rotate antenna on pipe. Rota-	T
tion can be up to 90°.				T
			T	T

Step 2. To adjust the elevation angle, loosen the bolt and nut at the bottom of the curved slot.

CAUTION: TO REDUCE RISK OF ELECTRICAL SHOCK,

DO NOT REMOVE COVER, NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED PERSONNEL

Adjust the angle of the antenna.

1.All the safety and operating instructions should be read before the appliance is operated.

2.The safety and operating instructions should be retained for future reference.

3.All warnings on the appliance and in the operating instructions should be adhered to.

4.All operating and use instructions should be followed.

5.Unplug this video or audio product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for clean- ing.

6.Do not use attachments not recommended by the video product manufacturer as they may cause hazards.

7.Do not use this video product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like.

8.If slots, holes and openings are located in the housing, they are provided for ventilation and to ensure reliable operation of the video product and to protect it from overheating. These open- ings should never be covered. The openings should never be blocked by placing the video product on a bed, sofa, rug, or other similar surface. This video product should never be placed near or over a radiator or heat register. This video product should not be placed in a built-in installa- tion such as a bookcase or rack unless proper ventilation is provided or the manufacturer's in- structions have been adhered to.

9.This video product should be operated only from the type of power source indicated in electri- cal rating printed on the appliance or power sup- ply.

2

10A. If the appliance is equipped with a polarized alternating-current line plug (a plug having one blade wider than the other) this plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact an electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

10B. If the appliance is equipped with a 3-wire grounding-type plug, a plug having a third (ground- ing) pin, this plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug.

11.Power-supply cord should be routed so that it is not likely to be walked on or pinched by items placed upon or against it, paying particular

attention to cord at plug, convenience receptacle and the point where cord exits from the appliance.

12. If an outside antenna or cable system is con- nected to this video product, be sure system is grounded so as to provide some protection against voltage surges and built-up static charges. Proper method is shown at the top of the next page.

13. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

14. For added protection for this video product during a lightning storm, or when it is left unat- tended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system.

T	T
STEP 3. To adjust the skew, loosen the 4 bolts
holding the elevation bracket. Now twist (turn) the
antenna for the best picture.		T
Figure 5		T

Skew bracket bolts.

Loosen to adjust tilt, Step 3.

Pipe clamp bolts.

Loosen to adjust azimuth,

Step 1.

Elevation angle bracket bolt.
Loosen to adjust elevation angle,
Step 2.	Rotation bracket.

7