Winix Air Cleaner manual Using the Remote Control

REMOTE CONTROL

*5000B does not come with remote a control.

PREPARATION

• Press and slide the back cover of the remote to remove.

• Insert batteries as shown.

• Close the back cover.

BATTERY USE

•The batteries for the remote control are for initial use only. Change the batteries when necessary.

•When replacing the batteries, replace both at once with 2 new AA batteries.

•Incorrect battery usage may cause battery fluid leakage and/or damage.

•When not using the remote control for an extended period of time, remove the batteries.

•Avoid dropping or damaging the remote control. Keep remote control away from direct sunlight or heaters.

USING THE REMOTE CONTROL

Proper conditions

•Operate the remote control facing the air cleaner.

•Operate within 20 feet of the air cleaner.

Poor conditions that may impair operation

•Any location where there is inverter lighting equipment or electronic spontaneous lighting equipment.

•When objects or furniture are located between remote and air cleaner.

•When air cleaner unit is located in direct sunlight.

•In areas where fluorescent lighting is flickering due to worn out bulbs.

POWER

Use the POWER button to turn the power on and off. A short "beep" will sound when you turn the unit on or off. Once the unit is on, it will automatically switch into Automatic operation. Turn the unit to manual control by pressing one of the FAN CONTROL buttons.

TIMER

This button is used to set the timer. Press the button repeatedly to set the unit to run for 2 or 4 hours or to cancel. Each time you press the button, it will advance to the next pre-set amount of time. The indicator light on the unit will show the remaining amount of time. The unit will stop operating when the set amount of time runs out.

FAN CONTROL

•UP

Use this button to switch from Automatic operation and increase the fan speed level.

•DOWN

Use this button to decrease the fan speed level.

TURBO

Use this button to switch from Automatic operation and begin the maximum amount of room cleaning and air movement.

AUTO/SLEEP

•When unit is first turned on it automatically defaults to auto mode.

•Pressing AUTO/SLEEP button once activates Energy Saving mode. (Fan speed will not increase past level three.)

•Pressing AUTO/SLEEP button a second time activates Sleep mode. (Fan speed will not increase past level one.)

PLASMA ON/OFF

Use this button to turn the PlasmaWaveTM generator on or off.

9