User manual W3532
- 14 -
empty, wash and attach it again on order to be dried very
quickly. If there are any reminders of grass on the walls of the
bag, it is necessary to clean it so that the material can breathe.
Wash the plastic parts of the body with water and a sponge
dipped in washing detergent and pay attention so that the
engine and parts of the electrical installation are not in
contact with water.
Fig.12
Never use a high-pressure cleaner or aggressive detergent
for washing the body, engine and electric actuator.
If these principles are not complied with, there is the risk
of the expiration of the warranty.
Storage and not using the machine for long
periods
Store the self-moving rotary cutter in a dry place protected
against atmospheric influences and cover it, if possible. If the
machine will not be used for a long time (longer than one
month) it is necessary to disconnect the red cable from the
accumulator and follow the instructions in the Manual for the
engine). Emptying the fuel tank
Regularly check that the voltage in the accumulator has
not decreased below 12V. Charge it, if necessary
With respect to the protection of the environment, take
care to prevent the escape of oil, fuel or other harmful
substances.
All repairs, maintenance and treatment of the machine is
to be performed when the engine is not active when the
ignition key is removed.
Front axle - Fig.13
After five hours of operation, tighten the bolt (1) on the arm of
the left vertical pin. The bolts (2) serve for setting the
clearance of the front axle in the frame.
Fig.13
Gearing – Fig.14
After 5 hours of operation of the machine, adjust the free
gearing by turning the accessible pin downward from the
machine. Using the pin (1) it is possible to turn after loosening
the two nuts (2). After setting the clearance of the nut, fully
tighten.
Fig.14
Engine
Proceed according to the instructions of the Service and
Maintenance Manual (air cleaner, fuel cleaner, replacement of
oil, cleaning of ignition sparks, etc.).
The engine oil is discharged into the prepared vessel by
unscrewing cap “Z” on the discharging hole Pic.14. During
the replacement or discharging of oil always hold the neck
of the discharging tube with an hexagonal wrench, so as not
to loosen the tube when removing the cap! Otherwise there is
the risk of the unwanted escape of oil!
Electromagnetic clutch – Fig.15
The clearance between the rotor and the body of the
electromagnetic clutch must be within the range 0.35-0.5 mm
(the higher value is for summer operation). The adjustment is
performed by tightening (loosening) the 3 bolts position 1
Fig.15.