User manual W3532
- 5 -
Marking
Each self-moving rotary cutter is delivered marked with a
name-plate which contains the most important data and the
serial number. The serial number and the year of production
must be stated in the case of each request for technical service
and for each order of spare parts.
Service
This Manual contains the instructions for the control of the
self-moving rotary cutter and for the correct basic maintenance
which is performed by the user. For performing actions which
are not described in the Manual it is necessary to contact the
seller or the authorized service.
Spare parts
In the case of repair it is necessary to exclusively use spare
parts which ensure safety and replacement. Each order of spare
parts must include the serial number and the year of
production.
For spare parts it is necessary to proceed according to the
manual concerning the engine.
Warranty
The warranty is provided according to the instructions in the
Warranty certificate.
For the engine warranty, the terms of the respective
producer are valid.
We recommend using only the additional equipment
which is stated by the producer of the W3532 grass cutter,
otherwise there is a risk of the expiration of the warranty. The
possible connection of the other additional equipment must be
consulted with the producer!
Due to the storage and transport, some construction groups of
the self-moving rotary cutter are not assembled directly in the
production plant but during the commissioning. The client
must inspect the completeness of the machine. It is necessary
to proceed according to the following instructions:
Unpacking
After removing the package it is necessary to check all
individual parts of the machine and the freely packed parts. It
is also necessary to take care to prevent damage to the cutting
mechanism when removing from the palette.
The standard package contains:
- self-moving rotary cutter
- wheel
- seat
- parts of the grass storage bin
- bag with documents and User Manual
- bag with pin for securing the wheel, 2
ignition keys
- 1 spare 10A, 40A fuses and 1 spare bulb
- parts for the assembly of the seat 2 bolts, 2
braces, 2 pads, 2 nuts.
Assembly of the wheel – Fig 1a
1. Mount the wheel on the exceeding shaft
2. Face the hole of the wheel and the shaft with
the delivered pin.
3. Fix with the hammer inside and check that it
appears on the opposite side. (We
recommend to use a cutting drift or screw
driver)
Fig.1a
Attaching the seat – Fig.1b
a. Attach the braces into the hole of the seat
console (1).
b. The seat is placed onto the seat catchers (2)
on the machine.
c. Place and tighten the bolts in position (3) and
connect the switch of the seat by attaching
the connectors on the outlets of the switch.
Fif.1b