User manual W3532
- 8 -
Due to the transport, the self-moving rotary cutter is delivered
without motor oil and fuel. Before the activation of the
engine it is necessary to fill up the engine box with oil, and
it is necessary to comply with the regulations of the Service
Manual for the engine. Measure the level of the engine oil
when the engine is disconnected which must be between the
MIN and MAX lines of measuring bar “T” Fig.5. Using the
filler, fill up the tank with fuel and take care not to over-fill the
fuel. The tank holds approximately 9 litres The type of fuel
and oil which are to be used are stated in the service manuals
for the engine.
Inflation of tyres
The correct inflation of the tyres is the basic precondition for
levelling the cutting mechanism and for the achievement for
proportionally cutting the lawn.
Before inflation it is necessary to remove the cover and
connect to the valves the pressure air pump equipped with the
pressure gauge. Due to the use of tube-free tyres, a manual air
pump is not recommended for the inflation of tyres.
Inflation of front wheels 1.4 bar
Inflation of rear wheels 1 bar
Grass bag
Place the tank on the guiding according to Fig. 2a and check
the tightening of the fabric and the placement of the bag.
Rear axle – Fig.5b
The axle is filled with 0.8 L of PP90 oil.
Filling hole -1
Discharging hole -2
Check hole -3
Note: In the case of the correct height of the level, the oil will
start to discharge from the stable axle from the open check
hole.
Fig.5b
Important!
The bag or the cover against the stones controls the switch
which blocks the switching of the electromagnetic clutch for
the driving of the cutting mechanism. In the case that the bag
or the cover against stones is not connected, it is not possible
to disconnect the cutting mechanism. It is forbidden to
disconnect this mechanism or restrict its efficiency. The
spaces between the cap and the switch must be cleaned from
cut grass during the work, if necessary> In the case of filling
this space with grass it is not possible to run the engine when
the bag is attached.
Checking the blades
Check that the blades are well sharpened and whether the
respective hubs are reliably fixed. Incorrectly sharpened
blades can upland the grass and cause yellowing of the
lawn.
4.3 Commissioning
Parking brake
Braking with the parking brake is performed by pressing the
foot brake pedal, the relocation of the “P” lever in Fig.6
backwards in the direction of the arrow, releasing the brake
pedal and releasing the lever. The foot pedal remains in the
lower position. The release of the brake is performed by
pressing the brake pedal which causes the automatic release of
the braking brake and the lever “P”.
Fig.6
Fig.7