Wolfgang Puck BFPR0040 Before Your First Use, Overload Protection Reset Switch

HSN_4CupFoodProcManual08_2 8/22/08 1:31 PM Page 7

Before Your First Use

Prior to using your Food Processor, wash all parts as outlined in the section “Care and Cleaning.”

Overload Protection

Reset Switch

Your 4 Cup Food Processor is equipped with an overload protection switch. Should your food processor stop working, unplug it from the wall outlet. Wait for the motor to cool down (about 5 minutes) and follow the instructions below.

figure a	1	Ensure that your Food Processor
		is powered off and unplugged from the
		wall outlet.
	2	Remove the Storage Drawer from the
		Motor Housing
	3	Locate the red RESET button located
		underneath the Motor Housing (see figure
		a) Press the button in completely.
	4	Assemble your Food Processor according
		to the instructions in the section
		“Assembling Your Food Processor. Plug the

food processor into the wall outlet. Your Food Processor is now ready to for use.

Assembling Your

Food Processor

figure 1

Before you assemble the Food Processor, ensure that the power cord is unplugged.

1Place the Motor Base facing you on a dry,

level surface.

	2	Place the Processing Bowl onto the Motor
		Base, the bowl will only sit correctly on the
		base when the handle is at the 3 o’clock
		position, see figure 1.
figure 2	3
		Rotate the handle clockwise to lock, as
		indicated by the graphics on the left side
		of the motor base. The Bowl Handle should
		be at the 6 o’clock position, see figure 2.
	4	Place the Lid on the Processing Bowl
		with the tab on the Lid to the right of the
		handle. See figure 3. Ensure that the center
		pin of the Lid is inserted into the hole on
		the shaft. Turn the Lid clockwise until it
		engages the interlock on the handle.
figure 3
		See figure 4.

Note: Your Food Processor will not operate unless your bowl and lid are assembled properly.

Warning: Use caution, as blades are extremely sharp. Always handle all blades by their central plastic section. Never grasp the cutting blade itself.

figure 4

7 8