Install Hydraulic Block and Fittings

1.Locate the hydraulic manifold block on the right side of the tractor just under the fender (Figure 19) and remove the block-off cap.

2.Attach hydraulic block (18) to tractor using new o- rings (14), three cap screws (8) and one cap screw (9) plus washers (7). Make sure o-rings are properly seated during installation.

3.Install elbows (15) and (11) into ports shown in Figure 20. Point elbows rearward.

Figure 19. Hydraulic Manifold Location

7.2472 5/16 Lock washer

8.307130 M8 x 1.25P x 40 mm Cap screw

9.307134 M8 x 1.25P x 100 mm Cap screw

11.313049 Elbow, 9/16 ORBM x 9/16 JICM

14.62726 O-ring .487 x .103

15.63558 Elbow, 9/16 JICM x 9/16 ORBM

18.1011423 Hydraulic block

Figure 20. Hydraulic Block and Fitting Installation

Install Hydraulic Hoses

1.Attach male quick coupler (17) to end of hose (2).

2.Connect opposite end of hose (2) to 90-degree elbow (15) in the hydraulic block. Route hose over rear axle and out the back of the tractor.

3.Attach straight end of hose (12) to 45-degree elbow (11) on the hydraulic block.

4.Attach 90-degree end of hose (12) to elbow (13) connected to the bulkhead adapter bracket.

215

11

1312

DP13

Figure 21. Hydraulic Hoses Installed

2. 1009493 Hose, 40" x 3/8 NPTM x 9/16 JICF

11.313049 Elbow, 9/16 ORBM x 9/16 JICM

12.360215 Hose, 14" x 9/16 JICF x 9/16 JICF

13.38604 Elbow, 9/16 JICM x 9/16 JICF 90°

15.63558 Elbow, 9/16 JICM x 9/16 ORBM

17.64300 Quick coupler, male

Figure 22. Hydraulic Hose Installation

12 Installation

MAN0406 (Rev.9/7/2007)

 

 

Page 12
Image 12
Woods Equipment 1013460 installation manual Install Hydraulic Block and Fittings, Install Hydraulic Hoses