Woods Equipment 1013460 Backhoe SUB-FRAME Installation, Tractor Preparation

BACKHOE SUB-FRAME INSTALLATION

Tractor Preparation

■Only use 1013460 4-Point Sub-Frame Mount-

ing Kit for mounting Woods BH70-X, BH80-X, BH6500, BH7500 backhoe on New Holland®

T2220, TC29DA, TC33DA, TC34DA tractors or Case IH® DX34, Farmall® 31, Farmall 35 tractors equipped with Woods LS84, LC96, LC102, 1009 and 1012 loaders, New Holland 14LA loader or Case IH L340 loader. Any other use or modifica- tion of this mounting kit may result in serious injury or death.

For installing this sub-frame, references to right, left, forward and rearward directions are determined from the operator’s position in the tractor seat.

Do not install 1013460 4-point sub-frame on a tractor without a Woods or OEM loader mount attached.

Refer to the WOODS Backhoe Operator’s Manual for backhoe assembly instructions.

Leave all hardware loose until sub-frame has been fit up or otherwise specified in the instructions.

This mount can be installed on tractors equipped with

aNew Holland mid-mount mower. Sub-frame can be installed with mower attached but may be easier if mower is removed from tractor.

1.Place jackstands under rear axle and remove both rear tires.

2.Disconnect the anti-sway bars (Figure 1) from the anti-sway brackets and remove front half. Store front half of anti-sway bars for later use when backhoe is removed.

3.Attach back half of anti-sway bars to the side of 3- point arm to prevent them from pivoting during backhoe operation.

4.Remove top link.

5.Remove ROPS hardware and spacer from both sides of rear axle. See Figure 2.

6.With spacer removed, cut bottom flange off of spacers. Spacer will be reused when sub-frame is installed. Make sure cut is flush with side flanges. See Figure 3.

DP11

Figure 1. Remove Front Half of Anti-Sway Link Bars

(Right Side Shown)

Figure 2. ROPS Hardware and Spacer - Right Side

Flush

DP2

Figure 3. Remove Flange

As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau- lic hoses have been installed, please take a few minutes to complete the Sub-Frame Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help us continue to bring you quality products.

(Rev. 5/2/2008) MAN0406 (Rev. 9/7/2007)

Installation 5