Install Cross Brace
1. | Remove PTO shield. | 6. | 1013477 | Cross brace |
|
| |||
2. | Attach cross brace (6) to rear of tractor using two | 20. 1026373 | M16 x 2.0P x 40 mm HFS CL10.9 | |
| hex flange screws (20). | 21. | 1093 | 1/2 NC Hex nut |
|
| |||
3. | Attach to right and left tractor brackets using four | 26. | 3699 | 1/2 NC x 2 HHCS GR5 |
| (two per side) cap screws (26), eight hardened | 28. | 57816 | 1/2 Hardened flat washer |
| flat washers (28), and four hex nuts (21). |
|
|
|
4.Install PTO shield.
26
28
20
Figure 11. Cross Brace InstalledFigure 12. Cross Brace Installation
Install Reinforcement Brackets
1. | Place reinforcement bracket (7) on the outside of | 3. | 1022130 | Right tractor bracket | |
7. | 1022126 | Reinforcement bracket | |||
| right tractor bracket. | ||||
| 23. | 230 | 5/8 NC hex nut | ||
|
| ||||
2. | Secure to front holes using two cap screws (32), | 29. | 57817 | 5/8 Hardened flat washer | |
| six hardened flat washers (29), and two hex nuts | 32. | 902 | 5/8 NC x 2 HHCS GR5 | |
| (23). | ||||
|
|
|
|
3.Secure to rear holes using two cap screws (32), six hardened flat washers (29), and two hex nuts (23).
4.Repeat steps to install bracket (7) on left side.
Figure 13. Offset Bar Installed, Right Side | Figure 14. Offset Bar Installation, Right Side |
MAN0708 (4/11/2008) | Installation 9 |
|
|
