Woods Equipment 1022120 manual Backhoe SUB-FRAME Installation, Tractor Preparation

BACKHOE SUB-FRAME INSTALLATION

Tractor Preparation

■Only use 1022120 4-Point Sub-Frame Mount-

ing Kit for mounting Woods BH70-X, BH80-X backhoe on New Holland® T1510, T1520 tractor equipped with Woods LS84, LC96, LC102, 1009, 1012 loaders or New Holland 7308, 110TL loaders. Any other use or modification of this mounting kit may result in serious injury or death.

For installing this sub-frame, references to right, left, forward and rearward directions are determined from the operator’s position in the tractor seat.

Do not install 1022120 4-point sub-frame on a tractor without a Woods or New Holland loader mount attached.

Refer to the WOODS BH70-X, BH80-X Backhoe Operator’s Manual for backhoe assembly instruc- tions.

Leave all hardware loose until sub-frame has been fit up or otherwise specified in the instructions.

This mount can be installed on tractors equipped with

aNew Holland mid-mount mower. Sub-frame can be installed with mower attached but may be easier if mower is removed from tractor.

1.Place jackstands under rear axle and remove both rear tires.

2.Disconnect the tractor anti-sway links from the axle brackets (Figure 1). Secure sway links to 3- point arms.

3.Remove top link.

4.Remove ROPS hardware from both sides of rear axle. See Figure 2.

DP17

Figure 1. Disconnect Anti-Sway Links

(Right Side Shown)

DP1

Figure 2. ROPS Hardware - Left Side Shown

As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau- lic hoses have been installed, please take a few minutes to complete the Sub-Frame Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help us continue to bring you quality products.

MAN0708 (4/11/2008) Installation 5