Grizzly G0622 Installing Work Stop Vertical Assembly, To assemble the bandsaw for vertical cut

Figure 15. Work stop locking lever.

G0622 4" X 6" Metal Cutting Bandsaw

Locking

Lever

Installing Work Stop		Vertical Assembly
	The Model G0622 can easily be set up for vertical
The work stop is designed to provide the operator
a quick reference for making multiple cuts at the	cutting operations.
same length.
To install the work stop onto the bandsaw:	Components and Hardware Needed:								Qty
	Table								1
	Table Bracket								1
1. KEEP BANDSAW UNPLUGGED!	Flat Head Screw				1	⁄4"-20 x	1	⁄2"	1
	Switch Safety Bracket								1
2. Install the work stop shaft into the side of the	Hex Nut		1	⁄4"-20					1
bandsaw then lock it in place by tightening
the setscrew (see Figure 14).	To assemble the bandsaw for vertical cut-
	ting:
	1.	Remove the two flat head screws and the
		blade guide cover shown in Figure 16.
		Blade Guide Cover

Figure 14. Installing work stop shaft.
		Figure 16. Blade guide cover.
3. Slide the work stop onto the end of the shaft	2.	Install the table and replace the two screws
and lock it into position with the locking lever
		removed in Step 1.
shown in Figure 15.
	3.	Install the table bracket shown in Figure 17
		with the bolt (already in the casting), the flat
		head screw, and the hex nut.

Bolt Already

in Casting

Figure 17. Table and bracket installed.

-17-