Grizzly G0622 owner manual Blade Selection, To change the blade speeds

To change the blade speeds:

1.UNPLUG THE BANDSAW!

2.Loosen the motor tension bolt to allow the motor to pivot (Figure 26).

Motor Tension Bolt

Figure 26. Motor tension bolt.

3.Raise the motor to relieve the belt tension and position the belt in the desired pulley alignment.

4.Release the motor and let the motor weight tension the belt.

5.Tighten the motor tension bolt back against the frame of the bandsaw.

-22-

Blade Selection

When selecting blades, keep in mind that the Model G0622 accepts only 1⁄2" x 0.028 x 641⁄2" blades.

When deciding which type of blade to use, con- sider the type and thickness of material being cut. Refer to Figure 27 for recommended blade tooth (TPI) and speed (FPM) based on the workpiece material. The blade must have at least three teeth in contact with the workpiece.

Example: 24 TPI blade minimum workpiece thick- ness is .125" or (3/TPI). The teeth can strip off the blade if fewer than three teeth are in contact with the material.

��������	���	���
		�
�����������	��	��
���������������
��������������
����������
����������	��	���
������
����������
��������	��	���
������������������

Figure 27. Model G0622 Blade chart.

G0622 4" X 6" Metal Cutting Bandsaw