SECTION 4: OPERATIONS
Operation Safety |
| Vise |
|
|
|
|
|
|
Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving machinery.
NOTICE
If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
Electrocution Hazard. The motor and switch on this bandsaw are not protected against liquids. Do not use cutting fluids with this bandsaw. Serious injury could occur.
Always turn the saw OFF and allow the blade to come to a complete stop before using the vise! Failure to follow this caution may lead to injury.
The vise can hold material up to six inches wide and be set to cut angles from 0 to 45 degrees.
To adjust the angle on the vise:
1.Loosen the lock nut with a 12mm hex wrench or socket as shown in Figure 22.
2.Use the scale as a guide to set your angle or use a machinist square to square the blade to the vise as shown in Figure 23.
3.Tighten the lock nut.
Figure 22. Setting vise angle.
G0622 4" X 6" Metal Cutting Bandsaw |
