Install Right Mount
1.Attach right mount (1) to tractor chassis and frame using four hex flange screws (7) and
2.Attach to tractor frame using two cap screws (4) and hardened flat washers (8).
3.Torque hardware to:
M14 x 2.0P x 40 mm . . . . . . . 111
1. 1023010 Right mount
4.1024088 M20 x 2.5P x 100 mm HHCS CL10.9
7.1028750 M14 x 2.0P x 40 mm HFS CL10.9
8.1006371 3/4 Hardened flat washer
9.1026300 14 mm
7
9
8
4
DP1
Figure 3. Right Mount Installed
Install Left Mount
1.Support fuel tank with hydraulic floor jack and remove strap on bottom of tank. Lower tank for access to mounting pad. See Figure 4.
2.Attach left mount (2) to tractor chassis using four hex flange screws (6) and
(9).
3.Attach to tractor frame using two cap screws (4) and hardened flat washers (8).
NOTE: Make sure electrical wires are placed between mount and tractor, and are not pinched. Coolant lines should be on the out side of the mount.
4.Torque hardware to:
M14 x 2.0P x 40 mm . . . . . . . 111
5.Raise fuel tank back into position and secure using hardware previously removed.
2. 1023011 Left mount
4.1024088 M20 x 2.5P x 100 mm HHCS CL10.9
6.1028719 M14 x 2.0P x 60 mm HFS CL10.9
8.1006371 3/4 Hardened flat washer
9.1026300 14 mm
DP2
Figure 4. Lower Fuel Tank
4
8
9
6
DP3
Figure 5. Left Mount Installed
MAN0572 (Rev. 1/30/2009) | Mount Installation 5 |
|
|
