Install Hydraulic Fittings
1. Locate the control valve under the right side of | 2. | 1012055 | Adapter, M18 x 1.5P x 3/4 JICM | |
the operator platform/cab and remove the four | 4. | 26124 | Quick coupler set, male/female 1/2 | |
plugs from the valve work ports. | 6. | 313053 | Elbow, 1/2 NPTM x 3/4 JICF 90° | |
| ||||
2. Install two adapters (2), elbows (6), and female | 7. | 315058 | Adapter, 1/2 NPTM x 3/4 JICF | |
half of quick coupler set (4) into the two forward | 8. | 395058 | Dust cap and plug set, black | |
ports of the control valve. Position elbows to point | ||||
9. | 395061 | Plastic spiral band, red | ||
forward. | ||||
10. | 395062 | Plastic spiral band, blue | ||
3. Install two adapters (2), adapters (7), and female | ||||
11. | 56061 | Plastic spiral band, green | ||
half of quick coupler set (4) into the two rear ports | ||||
12. | 56062 | Plastic spiral band, yellow | ||
of the control valve. | ||||
|
|
|
NOTE: Install colored bands and dust plugs between female quick coupler and fittings. See Figure 12 for colored band locations.
DP8A
Figure 11. Hydraulic Fitting Installed, Bottom View | Figure 12. Hydraulic Fitting Installation |
Install Hose Guide
Attach hose guide (3) to the right loader mount shoe using two carriage bolts (13), hardened flat washers (14), and hex nuts (15) as shown in Figure 13.
NOTE: Carriage bolts must be installed so that the heads are inside the loader mount shoe as shown.
3. 1020934 Hose guide
13.5607 5/8 NC x
14.57817 5/8 Hardened flat washer
15.230 5/8 NC Hex nut
Figure 13. Hose Guide Installation
MAN0572 (Rev. 1/30/2009) | Hydraulic Installation 9 |
|
|
