Woods Equipment FSW6000T, FSW6000F manual Assembly, Way Angle Mount Kit

					20
		8--1/4
				5	10
	TRIM INPUT SHAFT
			24	8	DRILL .343 (11/32) DIA
				21
			9		HOLES IN SWEEPSTER SHIELD
				7
				23
			22		6
					24
				2	4
				22
			CD4647A
	11			1	3
1.	Broom mount	7.	2-1/2" Clamp		21. 5/16" NC Flanged hex lock nut
2.	12V Actuator	8.	Extension spring		22. 1/2 NC x 2-1/2 Hex head cap screw
3.	Universal half sheet	9.	Upper actuator mount		23. 1/2 NC x 3 Hex head cap screw
4.	Universal half sleeve	10. Caster wheel assembly right			24. 1/2 NC Hex locknut
5.	Power shaft shield	11. Caster wheel assembly left
6.	Shield mount strap	20. 5/16" x 3/4" NC Hex head cap screw

Figure 3. 2-Way Angle Sweeper Installation

2-WAY ANGLE MOUNT KIT

(Figure 3)

Attach upper actuator mount (9) to square upright mast on Sweeper broom head using 1/2 x 3 bolt and 1/2 locknut.

Mark Sweeper input driveshaft at 8-1/4 inches from the center cross. Loosen the set screw retaining the rect- angular shaft and remove it from the U-joint. Cut shaft to proper length and reinstall shaft and secure with set screws.

Position broom head in front of mount while inserting broom head input shaft into sleeve assembly (4). Bolt broom head to mount (1) using bolts provided with broom head.

Attach fixed end of upper actuator (2) to mount using 1/2 x 2-1/2 bolt and 1/2 locknut. Attach rod end of actu- ator to slots in upper actuator mount (9) using 1/2 x 2- 1/2 bolts and 1/2 locknut. Slide broom head left or right

until actuator lines up with upper mount. Do not over tighten, rod must be able to float in slot. Attach wire from actuator motor to black and white wires from the switch box.

Attach extension spring (8) to hole in broom head mast and to hole in main mount near rear actuator mounting location.

Attach 2-1/2 clamp (7) and shield mount strap (6) to round cross member of broom frame. Do not tighten fully so shield may be adjusted. Attach power shaft shield (5) to strap. Position shield so it can be bolted to existing chain shield of broom head. Drill 2.343 (11/32) dia holes in broom head shield to mount power shaft shield. Bolt power shaft shield to broom head and tighten all bolts and clamps.

Attach broom and mount to tractor according to instruc- tion in the following section.

10 Assembly MAN0118 (Rev. 12/23/2004)