Woods Equipment FSW6000F Assembly, Dealer Set-Up Instructions, Fixed Angle Mount Kit Installation

ASSEMBLY

DEALER SET-UP INSTRUCTIONS

Assembly of this sweeper is the responsibility of the WOODS dealer. It should be delivered to the owner completely assembled, lubricated, and adjusted for normal cutting conditions.

FIXED ANGLE MOUNT KIT INSTALLATION

(Figure 2)

Mark Sweeper input driveshaft at 6-1/2 inches from the center cross. Loosen the set screw retaining the rect- angular shaft and remove it from the U-joint. Cut shaft to proper length and reinstall shaft and secure with set screws.

Position broom head in front of mount while inserting broom head input shaft into sleeve assembly (7). Bolt

6--1/2

TRIM INPUT SHAFT

17

16

CD4649A-1

SEE SWEEPSTER® MANUAL

FOR SWEEPSTER® PARTS.

broom head to mount (1) using bolts provided with broom head.

Attach height adjustment lever (2), and lever guide (18) as shown. Pivot bolt (35) and nut (37) must be snug but still allow the lever to rotate.

Secure one end of chain (17) to lug on adjustment lever using washer (40) and cotter pin (30). Attach mid- point of chain to slots in broom head lift arm. Secure chain to slots using pin provided with the broom head.

Attach assist spring (16) to hole in sweeper mount. Attach other end of spring to loose end of chain.

Attach broom and mount to tractor according to instruc- tions on page 12.

2

30

8

407

18

35

37

1

1.	Fixed angle sweeper mount	18.	Lever guide
2.	Lever	30.	Cotter pin
7.	Output shaft	35.	Hex head cap screw
16.	Spring	37.	Elastic stop nut
17.	20 - Link chain	40.	Standard flat washer

MAN0118 (Rev. 12/23/2004) Assembly 9