PIVOT BEARING REPLACEMENT
Two replacable bearings per pivot joint are located in:
Bearing Location | Wiper |
|
|
|
|
• Boom pivot (A) | X |
• Boom cylinder rod end (B) |
|
• Bucket cylinder rod end (C) |
|
• Loader boom bucket pivot (D) | X |
• Bucket linkage (E) | X |
• Boom guide link pivot (F) | X |
|
|
Bearing repair kits for LF138 and LF156 loaders are:
1018608 24 Bearing repair kit (All pivot points)
1018607 2 Bearing repair kit (For any 1 pivot point)
Replace pivot bearing as follows:
1.Remove loader from tractor.
2.Remove pivot pin from pivot location that needs to be replaced.
NOTE: Make sure to support upright and/or lift cyl- inders to prevent them from falling while the loader is being disassembled.
3.Remove both wipers (if present).
4.Remove both bearings from each pivot point.
NOTE: Hammer and punch or heat may be required to remove bearings.
5.Apply one drop of Loctite (supplied with bearing kit) to each new bearing and install bearing.
6.Allow Loctite to set one hour before reassembling loader.
7.Apply grease to all bearings. Allow grease to fill small cavities in bearing.
8.Install wipers, if required.
NOTE: Lip must be installed towards the outside of joint (Figure 36).
9.Reassemble loader.
Figure 34. Bearing Locations
Replaceable
Bearings
DP7
Figure 35. Replaceable Bearings (Typical)
Figure 36. Wiper Installation
MAN0556 (9/21/2007) | Dealer Service 29 |
|
|
