U-Line manual Light Bulb Replacement, Wine Rack Removal/Installation, 2275DWRWS, 2275DWRWOL

4

3

2

1

ULIN_0154a_A

Figure 24

3.Place finished drawer overlay panel (Figure 24, 3) over front of drawer and using masking tape, tape to front of drawer, making sure to center overlay and making the top and bottom flush with drawer.

4.Place drawer overlay bracket (Figure 24, 1)on bottom of drawer making sure to catch the back of the drawer with the short lip on bracket.

Also align the wood overlay with the ends of the bracket, and tape in place.

5.Mark center of holes from mounting bracket onto the wood overlay.

6.Using an ice pick, or similar tool, mark the location of the top mounting screws on the wood overlay.

7.Remove the lower mounting bracket and wood overlay from the drawer.

8.Using a #44 (0.094) drill, pre-drill pilot holes in the locations noted from steps 5 and 6, be sure to NOT drill through the overlay.

Drill the pilot hole from step 5, 9/16" deep and the ones from step 6, 1/4" deep.

9.Attach the bottom bracket to the wood using 2 of the 5/8" screws (Figure 24, 2) included with the unit.

10.Attach the wood overlay assembly to the drawer starting at the bottom of the drawer, then re-centering it on the drawer front.

11.Secure the top of the wood panel by placing 2 of the 1-1/2" wood screws (Figure 24, 4) through the top holes in the drawer, and tighten securely.

12.Repeat steps for bottom drawer.

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 25

1.Grasp the edges of the light housing lens

(Figure 25, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 25, 2).

2.Pull the edge of the lens down (Figure 25, 1) and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and will compromise the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

Wine Rack Removal/Installation

To remove a rack from the cabinet:

1.Grasp the end of the rack, and gently slide it out until it stops.

2.Remove any bottles stored on the rack.

ULIN_0155a_A

Figure 26

18 2275DWRWS, 2275DWRWOL