3.Press the left rack release lever (Figure 26) down, and at the same time, lift the corresponding right rack release lever up, and pull the rack out until it is free of the tracks and the cabinet.
IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1.Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops.
2.Before reloading the rack, ensure proper operation of the travel stops in the left and right track rails by pulling the rack out gently until it completely stops.
Wood Trim Finishing
The
WARNING
To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer’s instructions prior to reinstallation. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty.
If staining the trim is desired, it must be done before the application of any type of final finish. Review the following staining/final finish and final
NOTE: Glass in door is tinted. Stain may look darker when door is closed.
Staining and final finish application:
1.Remove all screws securing wood trim to interior components, and remove the trim from the cabinet interior.
To remove the top drawer display wood trim:
1 |
4 |
5 |
3 |
ULIN_0831_A |
Figure 27
2.Remove the two screws (Figure 27, 1), securing trim to wine rack assembly (Figure 27, 2).
NOTE: Your model will contain an electronic display panel (Figure 27, 3) in the middle level trim piece. After removing the trim screws, and gently pulling the trim from its location, a wiring harness connector
(Figure 27, 4) will become visible. Unplug the connector.
3.Remove the two screws, securing the electronic control to the wood trim. Carefully rotate the wood trim so the electronic control slides out of the wood, and place the electronic control aside in a safe location.
NOTE: The electronic control and glass front are NOT connected. Be careful when removing the control not to drop the glass.
3 |
1 |
2 |
ULIN_0145a_A |
Figure 28
4.Remove the two screws (Figure 28, 1) securing trim to wine rack assembly (Figure 28, 2).
2275DWRWS, 2275DWRWOL | 19 |