Side-to-Side Adjustment
Not Aligned |
Top View of Unit |
ULIN_0001c_A |
Figure 17
See Figure 17. The drawer will need a
Minor Adjustment:
NOTE: The mounting holes on the slide are slightly larger than the screws’ diameter.
Loosen |
Mounting Screws |
Push Slide |
Backward |
ULIN_0001d_A |
Figure 18
1.Loosen the slide’s mounting screws.
2.Push the slide backward.
3.Retighten the screws. See Figure 18.
Severe Adjustment:
NOTE: The slides have extra mounting holes that may be used.
Mark and Drill New
Mounting Holes
Push Slide
Backward
ULIN_0001e_A
Figure 19
1.Remove the slide’s mounting screws.
2.Reposition the slide so it is the same distance from the front of the liner as the other slide. Measure to confirm.
3.Mark new drilling holes using different sets of mounting holes on the slide. See Figure 19.
NOTE: Front location holes are shown. Corresponding rear holes will also need to be marked.
4.Drill all the new holes with a #30 drill bit.
5.Remount the slide.
Front-to-Back Adjustment
Not Aligned
Side View of Unit
ULIN_0001f_A
Figure 20
See Figure 20. The drawer will need a
16 | 2275DWRWS, 2275DWRWOL |