U-Line 2275DWRWS, 2275DWRWOL manual Adjust Drawers, Checking Drawer Alignment, Drawer Removal

Adjust Drawers

Checking Drawer Alignment

The unit’s drawers are aligned at the factory before shipment. However, their alignment could have been disturbed during shipment.

Aligned

Front-to-Back

Aligned

Side-to-Side

Aligned

Top-to-Bottom

ULIN_0001a_A

Figure 15

See Figure 15. Check each drawer to confirm that it is aligned:

•Side-to-Side— When viewed from the top, the drawer front should be square with the sides of the cabinet.

•Front-to-Back— When viewed from the side, the drawer front should be straight with the cabinet’s sides, not cocked forward or back.

•Top-to-Bottom— When viewed from the front, the drawer should be level horizontally.

If either drawer is not aligned, carefully follow instructions to remove that drawer, make the necessary adjustment and re-install the drawer.

Adjusting Drawer Alignment

WARNING

SHOCK HAZARD — The unit must be unplugged from the wall outlet during drawer removal, adjustment and re-installation.

Drawer Removal

Mounting

Screw

ULIN_0001b_A

Figure 16

1.Confirm that the unit is unplugged from wall outlet.

2.Unplug the drawer’s connection wiring (top drawer only).

3.Remove the mounting screws. See Figure 16.

4.Pull the drawer completely out of the unit.

CAUTION

Use care when handling the drawer. Drawer edges, drawer rail and the unit’s slide may be sharp.

IMPORTANT

Drawer adjustments are made by moving the slide that carries the drawer’s rail. Minor adjustments may be made by loosening one of the slide’s mounting screws, adjusting the slide and retightening the screw. Severe adjustments may be made by removing the slides’ mounting screws, drilling new mounting holes and remounting the slide.

2275DWRWS, 2275DWRWOL 15