5.Torque all hardware according to page 8.
4.70067 1/4 NC x 1/2
Whiz bolt
5.70065 1/4 NC Whiz nut
10.70068 1/4 NC x 3/4 Whiz bolt
2.Attach latch linkage rod (36) to both right and left door handle mount. Be sure to install spring bracket (35) into clevis when attaching left side (see Figure 7).
3.Attach opposite end of door linkage rod (45) to door handle mount.
4.Adjust linkage so that there is a slight amount of pressure holding the door closed when handle is snapped over center.
5.Attach opposite end of latch linkage rod to door latches.
6.Attach spring (34) to hole in side panel with spring anchor (35) on left side and to spring bracket (33) as shown in Figure 7.
7.Adjust latch linkage rods so that the door latches will release just before the door opens when the door handle is moved forward.
23.70026 Nylon bearing
24.70531 Door
29
48 40
31 32
39 40
45
26. | 70536 | Right door hinge |
27. | 70537 | Left door hinge |
Figure 6. Door Assembly
INSTALL DOOR HANDLE
NOTE: Turn hopper assembly over and support in upright position.
1.Attach door handle (29) to left door handle mount as shown in Figure 7.
2.Install stop lever (49) and rubber bumper (50) to right side panel as shown in Figure 8.
3.Install latch pivot bracket (42) to both sides of grasscatcher as shown in Figure 8.
4.Attach door latches (44) to latch pivot brackets. Adjust latch brackets (28) so that the door latches will hold the door tightly shut (see Figure 8).
INSTALL LINKAGE
1.Attach door linkage rod (36) to both right and left door hinge as shown in Figure 7 and Figure 8. Place head of clevis pin to the outside.
39 40
36
33
3435
29.70526 Hopper handle
31.1686 3/8 NC x 3/4 HHCS
32.15030 3/8 NC Flange lock nut
33.70546 Link
34.70834 Spring
35.1001501 Spring anchor bracket
36.70547 Linkage latch rod
39.70024 Clevis pin, 5/16 x 25/32
40.1326 Cotter pin, 1/8 x 1/2
45.70548 Linkage door rod
48.64151 Clevis pin, 3/8 x
MAN0115 (Rev. 3/31/2006) | Assembly 5 |
|
|
