Woods Equipment MAN0115 Assembly, Secure Hopper, Position Hood For Servicing Engine, Wrench

SECURE HOPPER

1.Rotate hopper onto right and left hopper supports.

2.Insert 3/8 lynch pins (18) to attach front hopper crossmember to support brace as shown in Figure 14.

18

18.33000 3/8 x 2-1/4 Lynch pins

Figure 14. Latch Locked into Position

POSITION HOOD FOR SERVICING ENGINE

To flip hood up for servicing engine, follow these steps:

1.Disconnect vacuum hose from hose adapter chute on vacuum.

2.Remove lynch pins from hopper support (Figure 14).

3.Tilt hopper assembly back.

NOTICE

■Do not attempt to tilt hopper to service position unless hopper is completely empty. Failure to empty hopper could result in damage to hopper.

4.On power unit, unhook rubber latches and lift hood assembly to service position.

5.Secure with prop rod.

DP5

Figure 15. Servicing Engine

		TORQUE SPECIFICATIONS
			Wrench		Hardware
Ref	Cap Screw	Qty	Size	Required Torque	Location
4	1/4 NC x 1/2 Whiz bolt	68	7/16	10 lbs-ft (13 N-m)	Hopper Assembly
6	3/8 NC x 1-3/4 HHCS	4	9/16	35 lbs-ft (47 N-m)	Mount Assembly
8	3/8 NC x 1 FHCS	12	9/16	35 lbs-ft (47 N-m)	Mount Assembly
10	1/4 NC x 3/4 Whiz bolt	14	7/16	10 lbs-ft (13 N-m)	Hopper Assembly
14	5/16 x 3/4 Sheet metal screw	4	1/2	19 lbs-ft (26 N-m)	Hopper Assembly
19	1/4 NC x 1-1/4 HHCS	1	7/16	10 lbs-ft (13 N-m)	Hopper Assembly
31	3/8 NC x 3/4 HHCS	2	9/16	35 lbs-ft (47 N-m)	Hopper Assembly

8 Assembly MAN0115 (Rev. 3/31/2006)