INSTALL REAR HOPPER SUPPORT & REAR HOPPER PIVOT
Align hinges of rear crossmember (12) on hopper with hinges of rear hopper pivot (4). Insert clevis pins (14) and hair pins (15) as shown in Figure 12.
1.Attach rear hopper support (3) to the rear of the power unit using four flanged head cap screws (8), standard flat washers (9), and two flange lock nuts
(7) as shown in Figure 11.
2.Attach the rear hopper pivot (4) to the rear hopper support using four flanged head cap screws (8), washers (9), and flange lock nuts (7).
ATTACH CABLE
1. | Attach cable (10) to rear of power unit on both right |
| and left sides as shown in Figure 13. |
| NOTE: Remove cap screw for ground cable on |
| 21D & 25L power units. |
2. | Secure with flanged cap screw (8), washer (9), and |
| flange lock nut (7). Leave hardware loose at this |
| time. |
3. | Remove the fourth whiz bolt and whiz nut from the |
| bottom of both right and left side panels. |
9
7 
8
8
7
4
3
8 7 9
4. | Install whiz bolt (16), other end of cable (10), flat |
| washer (9), and whiz nut previously removed in this |
| hole position as shown in Figure 13. |
5. | Pivot hopper back and allow weight of hopper on |
| cables. Torque hardware at this time. |
16 9
DP4
3.74082 Rear hopper support
4.73678 Rear hopper pivot
7.15030 3/8 NC Flange lock nut
8.62153 3/8 NC x 1 Flanged cap screw
9.565 3/8 Standard flat washer
Figure 11. Rear Hopper Support & Rear Hopper Pivot
MOUNT HOPPER ASSEMBLY
12
4
14
15
4. | 73678 | Rear hopper pivot | DP2 |
| |||
12. | 1000679 | Rear cross channel (Hopper) |
|
14.63523 3/4 x
15.2688 5/32 Hair pin cotter (2)
Figure 12. Hinge Pin Installed (Left Hinge Shown)
10
98 
7 
7.15030 3/8 NC Flange lock nut (2)
8.62153 3/8 NC Flanged cap screw (2)
9.565 3/8 Flat washer (4)
10.73957 Cable
16.70068 1/4 NC x 3/4 Whiz bolt (2)
Figure 13. Cable Installed (Right Side Shown)
(Rev. 8/17/2007) MAN0115 (Rev. 3/31/2006)
Assembly 7
