HOPPER ASSEMBLY
ASSEMBLE HOPPER
!LEA EL INSTRUCTIVO!
Si no lee Ingles, pida ayuda a alguien que si lo lea para que le traduzca las medidas de seguridad.
Only use grass collection system with dual tail- wheel option.
1. 70521 Hop-
per top
4.70067 1/4 NC x 1/2 Whiz bolt
5.70065 1/4 NC Whiz nut
6.1000664 Right side panel
7.1000665 Left side panel
8.70528 Upper front panel
9.70530 Back panel
11.1000667 Bottom panel
Figure 1. Hopper Assembly
Assembly of hopper will be easier if assembled upside down on a flat surface, see Figure 2. Note that Figure 1 shows hopper in the upright position.
NOTE: When assembling the hopper, make sure bolts that will interfere with grass clippings are installed with heads on the inside. This will prevent clippings from catching on bolts when the grasscatcher is dumped.
Leave hardware loose until hopper is assembled.
1.Lay top section upside down on a flat surface, using Figure 1 as a guide for assembly.
NOTE: Do not install bolts in side holes where upper and lower crossmembers will mount (refer to Figure 4, items 12 & 15).
2.Attach side panels (6, 7), upper front panel (8) and back panel (9) to hopper top (1). Make sure side panel corners are outside the front and back panels as shown in Figure 2.
3.Fasten bottom panel (11) to the side panels and to the outside of the front panel (Figure 1).
6
8
9 
7 
1 DP1
Figure 2. Assemble Hopper Upside Down
MAN0115 (Rev. 3/31/2006) | Assembly 3 |
|
|
